You should refer to your operating system manuals for interpretation of these messages.
#Xsort software software#
POSSIBLE ERROR IN DMAP INSTRUCTION %1 INSTRUCTION NO.%2 Nastran Dmap Error Message List 0-999ĮRROR IN DMAP INSTRUCTION %1 INSTRUCTION NO.%2 Xsort software commands manuals# *** USER FATAL/WARNING MESSAGE 8 (XGPIDG)īULK DATA PARAM CARD ERROR - MUST NOT DEFINE PARAMETER NAMED %1. User cannot set the value of the parameter with name %1 on a PARAM In DMAP, when defining a parameter, the "N" in V,N %1 means In DMAP, the "N" in V,N %1 or in TYPE PARM,A,B,N means userĬannot set the value of the parameter with name %1 on a PARAM entry. Here is a parameter in the referenced DMAP instruction which must The constant needs value in a DMAP instruction or on a PARAM entry. Too many or too few inputs are specified in the input for the Have a value assigned before the execution of the module. *** USER FATAL/WARNING MESSAGE 12 (XGPIDG)ĮRROR IN DMAP INSTRUCTION NO. %1, ILLEGAL CHARACTER IN DMAP INSTRUCTION NAME. The name of a module must be alpha-numeric characters, the firstĬharacter being alphabetic. *** USER FATAL/WARNING MESSAGE 13 (XGPIDG) Special characters are not allowed.įor example DMAP names like "8MOD" or "SETI=2" are not allowed. See XGPI module description in MFD section of NX NASTRAN The named DMAP refers to a non-existent module name. This parameter was used in a previous DMAP instruction which INCONSISTENT LENGTH USED FOR PARAMETER NAMED %3 In other cases, it may be necessary to divide the DMAP The usual cause is insufficient open core. Usually caused by early termination such as a LABEL statement See the NX NASTRAN DMAP Module Dictionary. TOO MANY PARAMETERS IN DMAP PARAMETER LIST *** USER/SYSTEM FATAL/WARNING/INFORMATION MESSAGE 17 (EVLMSG) Incorrect calling sequence for DMAP instruction.
#Xsort software manual#
Statement to the description in the NX NASTRAN DMAP Moduleĭictionary or the NX NASTRAN Programmer's Manual to find the error. LABEL named appears in more than one place in DMAP program.ĮXTRANEOUS 'ELSE' / 'ELSEIF' STATEMENT AT INSTRUCTION %1ĭATABLOCK NAMED %1 MUST BE DEFINED PRIOR TO THIS INSTRUCTION *** USER FATAL/WARNING MESSAGE 19 (XGPIDG) Xsort software commands manual# *** SYSTEM FATAL/WARNING MESSAGE 24 (XGPIDG)ĬANNOT FIND DATA BLOCK NAMED %1 ON DATA POOL TAPE Note that RF24D41 requires a DTIIN command.ĭATA BLOCK NAMED %3 MUST BE DEFINED PRIOR TO THIS INSTRUCTIONĭATA BLOCK NAMED %3 IS NOT REFERENCED IN SUBSEQUENT FUNCTIONAL MODULE USER ACTION: CHECK FOR CORRECT SPELLING, OR MISSING TYPE STATEMENT, AND RERUN.Ī common mistake is to forget that DMAP statements DMIIN and DTIINĪre required to read DMI and DTI matrices, respectively. Parameter is referenced in nonfunctional module, but is nowhere defined.Īn example is COND LBL,X where X is not a variable parameter in a module PARAMETER NAMED %3 HAS AN INCONSISTENT USER AUTHORIZATION The contents of /XDPL/ do not match contents of Pool Tape. LABEL name does not appear in LABEL instruction.
0 kommentar(er)
